Company Name:
* Address:
* Contact Name:
* Telephone:
Fax:
* Email:
Type #:
Pulley Facewidth (L):
Pulley Diameter (D):
Horsepower:
Belt Speed (V):
Voltage:
Phase:
Frequency:
Class H Insulation Thermal Overload Protection (GVTherm) Single Phase Dual Voltage VPI Winding Other, Please specify:
Construction Material: All Mild Steel Mild Steel Shell with Nickel Plated End Flanges and Stainless Steel Shafts Stainless Steel Shell and Shafts with Nickel Plated End Flanges All Stainless Steel USDA - Dairy Approved (All Stainless Steel) Other If other specify:
Hub Design (refer to above diagram): Please Select One Design A Design B USDA
Lagging: 1/4" Plain Black 1/4" Black diamond 1/4" Black Herringbone (chevron) 1/4" Plain White 1/4" White diamond 1/4" White Herringbone (chevron) 1/4" White USDA-dairy approved Nitrile 1/4" Black Urethane 3/8" Plain Black 3/8" Black diamond 3/8" Black Herringbone (chevron) 3/8" Plain White 3/8" White diamond 3/8" White Herringbone (chevron) 3/8" White USDA-dairy approved Nitrile 1/2" Plain Black 1/2" Black diamond 1/2" Black Herringbone (chevron) Other None If other specify:
Shell: Crowned (Standard) Flat Face Other (Drawing Required) If other specify:
V-Groove: A Section V Groove on Center B Section V Groove on Center C Section V Groove on Center Other (Drawing Required) None If other specify:
Modular Belting Sprockets: If required specify type:
Quantity of Sprockets Required/Supplied Per Pulley:
Electrical Power Outlet: Junction Box (standard) Cable Type (Cable length 6 ft) Other Cable Length: feet
Brake / Backstop Options: Electromagnetic Brake (RTM) Mechanical Backstop device (TBCW) clock wise rotation from the side with the electrical power outlet Mechanical Backstop device (TBCCW) counter clock wise rotation from the side with the electrical power outlet Manual Release Backstop device (MRBCW) clock wise rotation from the side with the electrical power outlet Manual Release Backstop device (MRBCCW) counter clock wise rotation from the side with the electrical power outlet None
Mounting Brackets: None Standard Nickel Plated Stainless Steel
Extra Options: Extended Special Shafts (Specify Shaft Length (SL): and Flat Length (FL): see above drawing) Vertically Mounted Reinforced Bearings Other (Drawing Required)
Quantity of Drum Motors required:
Matching Idler Pulley: No Yes, same specifications as above Yes, different specifications (please specify) Idler specifications:
Is this a "No Belt" application? Please Select One No Yes
General
* What is the application for this unit?
This pulley must be mounted horizontally, square to the conveyor frame and parallel to the idler pulley. The arrow on the shaft opposite to the connection box should be pointing upwards. If this is not the case, please give full details.
Comments / Other Instructions: